| Issue | Resolution |
|---|
No Audio | - Make sure the volume on the pixie is up high enough
- Up and down volume arrows on pixie
|
No Audio While Using Computer | - Follow all directions above
- Volume on computer must be turned up
- Make sure that VGA audio cable is plugged into the wallplate and computer
|
| No Audio While Using HDMI | - For HDMI, the audio needs to be up on the projector. If this is the issue, a remote should be taken to the classroom
- The computer's "Audio Out" should be set to the room's projector.
|
No Computer Image While Using VGA Cable | Configuring Computers for Projection - Click computer button on Pixie to change input
- Restart computer with everything connected and projector turned on
- If there are two computer inputs, tell them to switch to the other computer input to make sure they have the correct cable and input selected
- VGA cable must be properly hooked up to wallplate and computer
- Display resolution must be set to 1024x768
- (Other resolutions may work but this is optimum for the projector)
- Adjust laptop for either dual or external monitor support
- Check VGA adaptor to make sure no pins are bent or pushed in
- VGA adaptors usually have at least one missing pin. That is normal
- If using a Mac adaptor, unplug adaptor from computer end and plug it back in
|
Using a Combo Deck in this Classroom |
|