...
No Computer Image While Using VGA Cable
Configuring Computers for Projection
- Click computer button on Pixie to change input
- Button says “Comp”
- Restart computer with everything connected and projector turned on
- If there are two computer inputs, tell them to switch to the other computer input to make sure they have the correct cable and input selected
- VGA cable must be properly hooked up to wallplate and computer
- Display resolution must be set to 1024x768
- (Other resolutions may work but this is optimum for the projector)
- Adjust laptop for either dual or external monitor support
- Check VGA adaptor to make sure no pins are bent or pushed in
- VGA adaptors usually have at least one missing pin. That is normal
- If using a Mac adaptor, unplug adaptor from computer end and plug it back in